Bluetooth; Bluetooth - Connection - Kenwood KDC-BT370U Instruction Manual

Bluetooth®
• Depending on the Bluetooth version, operating system and the firmware
version of your mobile phone, Bluetooth features may not work with this
unit.
• Be sure to turn on the Bluetooth function of the device to make the
following operations.
• Signal conditions vary depending on the surroundings.
Bluetooth — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone
(supplied)
Microphone
input jack
Adjust the
microphone angle
Pair and connect a Bluetooth device for the first time
Press B SRC to turn on the unit.
1
2 Search and select the name of your receiver ("KDC-BT370U"/
"KDC-BT282U"/"KDC-MP382BT"/"KMR-D382BT") on the Bluetooth
device.
"PAIRING"
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically.
•
on the display window lights up.
•
the display window for 2 seconds.
" " indicator lights up to show the strength of the battery and signal of
the connected device.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
Secure using cord
[DEVICE DELETE] on page 21.
clamps (not supplied)
• A maximum of two Bluetooth phones and one Bluetooth audio device can
if necessary.
be connected at any time. To connect or disconnect the registered device,
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 21)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 22)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
"PASS XXXXXX" "Device name"
/ / : "BT1" and/or "BT2" indicator
: "BT1 CONNECTED" and/or "BT2 CONNECTED" appears on
"PRESS" "VOLUME
17
ENGLISH