Table of Contents
Advertisement
A: PRIOR TO INSTALLATION
READ THIS OWNER'S MANUAL IN ITS ENTIRITY.
B: CHOOSE A LOCATION
A central location is most desirable; however, the minimum run of pipe to the chimney should be the deciding
factor. Never attempt to handle the unit alone. We recommend using a handcart to position the heater.
C: CHIMNEY CONNECTOR
The connector pipe connects the heater to the chimney. The pipe must be a 6" diameter 24–gauge steel pipe.
Connect your stove to an approved flue system serving only one appliance (please refer to local building code.)
CAUTION: All pipe joints and the connection to the heater collar must be firmly secured.
D: BAROMETRIC DAMPER
A BAROMETRIC DAMPER must always be installed properly in conjunction with a stoker stove. Dampers are
available through dealers or plumbing/heating distributors.
A: TYPE OF FUEL
CAUTION: Use only Premium Reading Anthracite Rice. Contact your dealer or coal supplier for proper
selection.
B: STARTING AN ANTHRACITE COAL FIRE
1. Fill the hopper with Premium Reading Anthracite Rice Coal.
2. Looking at the grate you will notice that some coal has been deposited on the grate. Place an ample amount
of additional coal on the grate by hand or by moving the Carpet back a forth a few times. Place the fire
starter near the very top of the grate where the holes begin, grind the fire starter into the bed of coal as best
as possible and surround with additional coal. GELLED FIRE STARTER can also be used on the fire
starter bag to help with ignition.
3. Light the fire starter bag. Never hold the bag or any other fire starter in your hand.
4. As soon as the fire starter is ignited, plug the Combustion Blower into a wall socket. The Blower will
begin to feed combustible air through the grate. Within 10 minutes, the bed of coal surrounding the fire
Website: www.ReadingStove.com
Section 5: Installation and Placement
Section 6: Operating Instructions
Facebook & Twitter: @ReadingStove
Juniata RSFD-10
15
Hide quick links:
Advertisement
Table of Contents
