Advertisement
064-095
096-127
128-159
9
Shutter
160-191
192-223
224-255
10
Dimmer
0-255
11
Focus
0-255
0-005
006-127
12
Prism
128-189
190-193
194-255
0-191
13
Iris
192-223
224-255
14
Speed
0-255
0-019
020-029
030-039
040-079
080-099
100-119
15
Special
120-139
140-159
160-179
180-199
200-219
220-239
240-255
Strobe effect slow to fast
shutter open
Pulse-effect in sequences
shutter open
Random strobe effect slow to fast
shutter open
Dimmer 0%...100%
In(near) to out(far)
Prism swing out
Prism swing in
Forwards rotation from fast to slow
Prism rotation stop
Backwards rotation from slow to fast
Max. diameter to Min.diameter
Pulse opening fast to slow
Pulse closing slow to fast
max to min speed for Pan/Tilt
Color change normal
Color change to any position
Color & gobo change to any position
No function
Motor reset
Internal program 1
Internal program 2
Internal program 3
Internal program 4
Internal program 5
Internal program 6
Internal program 7
Internal program 8
2. 2. 2. 2. S S S S afety
afety
afety I I I I nstructions
afety
nstructions
nstructions
nstructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
If the device has been exposed to temperature changes due to environmental changes, do not switch
it on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for
smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
Advertisement
