Sharp Aquos Operation Manual page 94

>>
Using a PC
<<
Control of the TV (Continue)
Command format
Eight ASCII codes +CR
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0–9, x, blank, ?
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4
values are input for the parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response
code format".)
Any numerical value can replace the "x" on the table.
Response code format
Normal response
Problem response
(communication error or incorrect command)
Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM COMMAND
POWER ON R S
COMMAND SETTING
POWER SETTING P O
INPUT TOGGLE I T
SELECTION
TV I T
1-8 I A
NOTE
If an underbar (_) appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL
CONTENTS.
Any numerical value can replace the "x" on the table.
ENG 7-3
PARAMETER CONTROL CONTENTS
P W 0 _ _ _ Off
1 _ _ _ On [RS-232C]
2 _ _ _ On [IP]
W R 0 _ _ _ Power Off
1 _ _ _ Power On
G D x _ _ _ (Toggle)
V D 0 _ _ _
V D * _ _ _ 1: HDMI IN 1,
2: HDMI IN 2,
3: HDMI IN 3,
4: HDMI IN 4,
5: COMPONENT/
VIDEO IN
The Power On
command
rejected.
The Power On
command
accepted.
The Power On
command
accepted.
It shifts to
standby.
Power On
It input-
switches by
the toggle. (It
is the same as
an input
change key)
It input-
switches to
TV. (A channel
remains as it
is. (Last
memory))