Sharp Aquos Operation Manual page 57

>>
On-Screen Display Menu
<<
Example
Smart TV (Continue)
Wallpaper
Activating the function will display still images when the TV
is in standby mode.
Wallpaper Mode
Configures Wallpaper Mode settings.
Off:Nothing will be displayed.
Picture:Still images will be displayed when the TV is in
standby mode.
Clock: The clock will be displayed when the TV is in
standby mode.
Configure the clock settings.
NOTE
The clock mode can only be used when a network
connection has been established.
Finish configuring the network settings.
After you set the time once, the clock will continue to
operate even if you disconnect from the network.
However, you cannot switch the daylight saving time
setting when disconnected from the network.
Data Source
For the wallpaper, you can select either the still images pre-
installed in the TV or your favorite still images stored in the
USB memory device or SD memory card.
Pre-Installed: The images pre-installed in the TV will be
displayed in a slideshow.
SD/SDHC/USB: Your favorite images stored for the
wallpaper will appear.
If only a single still image is stored in the USB memory
device or SD memory card, that image will be displayed
as the wallpaper. When there are multiple still images in
the memory, all the images will be displayed in a
slideshow.
NOTE
Images are displayed in 3-minute intervals as a
slideshow.
When the TV is in Wallpaper mode, you can turn off the
TV by pressing and holding POWER on the TV for 5
seconds.
- Just before the TV turns off, the last image shown
when the TV was turned off appears briefly.
- Your settings may not be saved in some cases.
ENG 4-23
When you display images by using the USB memory
device or SD memory card:
Create a folder named "WP" in the root directory of the
USB memory device or SD memory card (the first
directory when the USB memory device or SD memory
card is opened), and store into the folder the still images
you want to display for the wallpaper.
You must insert the USB memory device or SD memory
card to the TV before turning off the TV.
If there are images on the USB memory device or SD
memory card but they do not appear on the screen,
switch to SD/USB mode and check whether the image
files on the USB memory device or SD memory card are
shown correctly.
Timer Setting
You can set the length of time the TV will remain in the
Wallpaper Mode.
3 hours/6 hours/12 hours/24 hours
NOTE
No buttons except for POWER work even while the still
images are being displayed.
If the ready-for-use USB memory device or SD memory
card is not inserted, the still images pre-installed in the
TV will be displayed in a slideshow even when "Data
Source" is set to "SD/SDHC/USB".
Because the USB memory device or SD memory card
cannot be detected immediately after the TV is turned on
from standby mode, the wallpaper pre-installed in the TV
may be displayed even when "Data Source" is set to
"SD/SDHC/USB".
The still images will be displayed until the set time has
elapsed.
Clock
Configures clock settings.
Set the type of clock to use in wallpaper mode.
Spring/Summer/Fall/Winter:A clock that represents the
corresponding season will be displayed.
Random:A randomly selected clock from among the four
types will be displayed.