Ups Setting - Orion Power Systems DC1000RT User Manual

3-5. UPS Setting

01: Output voltage setting

Interface
02: Frequency Converter enable/disable

Interface
03: Output frequency setting

Interface
There are three parameters to set up the UPS.
Parameter 1: It's for program alternatives. Refer to
below table.
Parameter 2 and parameter 3 are the setting
options or values for each program.
Setting
For 200/208/220/230/240 VAC models, you may choose
the following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac
240: presents output voltage is 240Vac
For 100/110/115/120VAC models, you may choose the
following output voltage:
100: presents output voltage is 100Vac
110: presents output voltage is 110Vac
115: presents output voltage is 115Vac
120: presents output voltage is 120Vac
Setting
CF ENA: converter mode enable
CF DIS: converter mode disable(Default)
Setting
You may set the initial frequency on battery mode:
BAT 50: presents output frequency is 50Hz
BAT 60: presents output frequency is 60Hz
If converter mode enable, you may choose the following output
frequency:
CF 50: presents output frequency is 50Hz
CF 60: presents output frequency is 60Hz
14