Page 1
Visit us at surebonder.com for our full line of products ® Model 5910 Cordless Stapler ® ® ® No.4 No.4 No.4 Narrow Crown No.8 No.8 No.8 Brad Nail Heavy Duty Staples 9/16”/14mm 1/4”, 5/16”,3/8”,1/2”,9/16” Operating Instructions Read All Safety Rules and Instructions Carefully...
Page 2
WARRANTY If you have any problems with this stapler, please call FPC Corporation toll-free at 1-800-860-3838 before returning it to the place of purchase. FPC Corporation warrants this stapler to be free from defects in material and workmanship, under normal conditions of use and when used in accordance with FPC operating instructions, for a period of 60 days from the date of purchase by the user.
Page 3
The 5910-B battery is designed for the Stapler 5910. Recharge this battery only with the stapler. charger supplied with the Stapler 5910. The battery must first be charged the full time of 5 to 6 hours approximately or when the red led light goes off on the charger. Failure to do so Use safety equipment.
Page 4
Description of the 5910 Power knob IMPORTANT SAFETY WARNINGS (CONT’D) Stapler Use and Care Do not force the stapler. Use this stapler for the correct application, for the job it Battery was designed to be used. When the stapler is not being used, store it out of the reach of children and do not Trigger allow persons not familiar with it or these instructions to operate the stapler.
Page 5
Battery Charging Service Before using the stapler, the battery must be fully charged. (Approximately 5 hours). Have the cordless stapler serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the cordless stapler is maintained. Do not recharge the battery after use if it is not to be used for an extended period of time.
Page 6
Loading the Stapler Read all instructions. Failure to follow all instructions could result in electric shock, fire and or serious injury. Remove the battery. Turn the stapler upside down. Using the stapler Squeeze the track release and pull out (Fig. 1). Determine length of staple to be used. Leg Length should be 2 1/2 times longer than thickness of material being stapled.
Need help?
Do you have a question about the 5910 and is the answer not in the manual?
Questions and answers