Advertisement
♦Name and functions of terminals
♦Name and functions of terminals
A
13
B
･ Always be sure to use the USB connection cable
which is included as an accessory with this product.
6
5
C
10
4
11
12
D
E
F
G
･ Never cut the insulation on the power wire or use it to power any other equipment. If the
rated current capacity of the power wire is exceeded, fire and electric shocks may result.
･ The wires should be secured with tape or a similar securing method to prevent any
obstructions while driving. If they get wound or entangled around components such as
the steering wheel, shifting lever, or brake pedal, accidents may result.
･ If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or
a similar wire insulating material around the connection to insulate it. If the connection is
not insulated, fire or accidents may result.
Wire colors and connection points for
Vehicle speed pulse signal wire
connection wires ② , ③ , ④ , ⑤ and ⑥
(Pink)
1B+ (Yellow)
Connect to the vehicle speed pulse signal
terminal.
Connect where power is constantly available,
Parking brake signal wire
regardless of the ignition key's position.
2Ground (Black)
(Light Green)
Connect where good body grounding is
Connect to the parking brake signal terminal.
Reverse signal wire (Violet/White)
available.
3ACC (Red)
Connect the reverse signal output of the
vehicle to this terminal.
Connect where the power comes on when
the ignition is in the ACC position.
4 Illumination power supply
B
USB connection terminal
(Orange/White)
Connect to a USB device such as
Connect to where power comes on when the
a flash drive, or to ECLIPSE Direct
vehicle light switch is turned on.
Cable for iPod (sold separately).
5Antenna power supply (Blue)
C
AV input terminals
Connect to the power antenna control
Connect to the output wire of external
terminal of the vehicle.
video equipment/device such as a VTR.
6Remote turn-on (Blue/White)
Yellow
Connect to the control terminal for the
White
external amplifier, etc.
Red
7Front speaker output wires
※ If using the ECLIPSE Direct Cable for
Connect to the front speakers.
iPod (sold separately), connect the RCA
White:
Left +
terminals of the Direct Cable for iPod.
White/Black:
Left -
As a result of doing this, it will not be
Gray:
Right +
possible to connect any other video
Gray/Black:
Right -
equipment/device.
8Rear speaker output wires
D
Rear view camera external input
Connect to the rear speakers.
terminal (4P)
Green:
Left +
Used with the ECLIPSE rear view
Green/Black:
Left -
camera (sold separately).
Violet:
Right +
E
Line-out terminals (Non fader)
Violet/Black:
Right -
Connect to the RCA input connectors
9 Steering remote control terminals
of an equalizer, or to the RCA input
Connect to the vehicle steering remote
connectors of a woofer amplifier.
control.
F
Line-out terminals (Front)
White/Blue: STR-SW1
Connect to the RCA connector of an
Brown: STR-SW2
external amplifier.
1
9
Never connect the power supply to the
speaker wires (No.7 and No.8),
otherwise it will cause damage to the
Caution
main unit.
AntennA plug
3
H
I
J
1
2
3
4
5
6
2
7
8
9
G
Line-out terminals (Rear)
Connect to the RCA connector of an
external amplifier.
H
VTR output terminal
Connect to the monitor with video
input.
I
Microphone input terminal
Connect to the accessory microphone
⑪ .
J
Voice recognition ON/OFF
switch connection terminal
Connect to the accessory voice
recognition ON/OFF switch ⑫ .
Tip
･ "Made for iPod" and "Made for iPhone"
mean that an electronic accessory has been
designed to connect specifically to iPod or
: Video signal
iPhone, respectively, and has been certified
: Audio (left) signal
by the developer to meet Apple performance
: Audio (right) signal
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note
that the use of this accessory with iPod or
iPhone may affect wireless performance.
･ iPhone, iPod, iPod classic, iPod nano, and
iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
･ The Bluetooth
word mark and logos are
®
registered trademarks of Bluetooth SIG, Inc.,
and any use of such marks by FUJITSU TEN
LIMITED is under license.Other trademarks
and trade names are those of their respective
owners.
Main unit connections
A
Not used (12P)
♦System connection example
♦System connection example
Tip
･ Install and connect all of the peripheral units before connecting them to the main unit.
･ Do not remove any of the protective caps (RCA, etc.) unless the connectors are in use.
･ Be sure to wrap the connection wires with tape (PVC tape) to insulate them.
･ Be sure to grip the connector's body. Rough tugging may result in broken wires or harnesses.
iPod
･ Always be sure to use the USB connection cable
which is included as an accessory with this product.
NOT USED
ECLIPSE
Direct Cable for iPod
(sold separately)
Yellow
TO ExTERNAL VIDEO
EqUIPMENT or
White
ECLIPSE Direct Cable
Red
for iPod
TO VEHICLE
Pink
SPEED PULSE
SIGNAL
Light Green
TO PARKING
BRAKE SIGNAL
ECLIPSE
Rear View Camera
Violet/White
(sold separately)
NON-FADER
TO SUB-WOOFER
( Remove caps when using
external
ub-woofer)
s
PRE-OUT. F
TO ExTERNAL
AMPLIFIER
PRE-OUT. R
( Remove caps when using
external amplifier)
9
1
ANTENNA PLUG
3
TO ExTERNAL VIDEO
EqUIPMENT
Yellow
( Remove caps when using
external video equipment)
Yellow
TO BATTERY+12V
(Permanent Supply)
Black
TO GROUND
Red
TO ACC (Power Supply)
Orange/White
TO HEAD LIGHT SWITCH
(Illumination (+))
Blue
TO POWER ANTENNA RELAY
(Supply)
Blue/White
TO REMOTE TURN-ON
(Amplifiers, etc.)
FRONT
SPEAKERS
REAR
2
SPEAKERS
White/Blue
TO STEERING
REMOTE CONTROL
Brown
090003-32190700
1104（CN）
Hide quick links:
Advertisement
