Troubleshooting - Dimplex DC10RCDH Instruction Manual

TROUBLE SHOOTING
Never try to repair or dismantle the air conditioner yourself. Unauthorized repairs may result in
the loss of warranty and can endanger the user and their property.
Problem
The air
conditioner
does not
operate.
The air
conditioner
does not
seem to
operate
efficiently.
The air
conditioner is
noisy.
The
compressor
does not
work.
The remote
control
does not
function.
If you have any issues with your unit, please contact Glen Dimplex on 1300 556
816 for your nearest service agent. Proof of purchase is required at the time of
service.
Cause
No power supply.
Error code E4 is shown,
indicating the internal water
container is full.
The start timer function is
active.
The air conditioner is in direct
sunlight.
Windows or doors are open.
The filters are dirty.
The air inlets or outlets are
blocked.
The room temperature is
below the set temperature.
The air conditioner is not
level.
The overheat protection is
activated.
The distance between the
remote control and the air
conditioner is too far.
The batteries are flat.
Solution
Connect to a functioning power supply
socket and switch on.
Empty the internal water container. (Refer to
WATER DRAIN)
Press the POWER button to deactivate the
TIMER function.
Close the curtains.
Close windows and doors.
Clean the filters.
Remove the blockage.
Lower set temperature.
Place the air conditioner on an even, solid
surface.
Wait 30 minutes until the temperature has
decreased, then restart the air conditioner.
Note: Compressor operation begins 3
minutes after the unit is switched on.
Move closer to the air conditioner. Aim the
remote control directly at the control panel.
Replace the batteries.
12