Care Of The Unit; Overheat Protection; Error Codes - Dimplex DC10RCDH Instruction Manual

CARE OF THE UNIT

1. Only plug the unit into a suitable 220-240V~ 50Hz AC 10 AMP power supply.
2. Hold the plug when unplugging the unit, never pull on the cord.
3. Do not place the unit in direct sunlight. This can fade the plastic case.
4. Do not operate the unit in a confined space.
5. Do not place objects on top of the unit. This blocks the air outlet.
6. Do not place the unit where the air inlets or outlets may be blocked by curtains or
furniture.
7. Keep the filters clean.

OVERHEAT PROTECTION

This unit is fitted with an overheat prevention device. If the unit overheats it will
automatically turn off. The unit can be restarted after 30 minutes.

ERROR CODES

Error codes are shown on the display should a fault occur.
E1: Indicates open circuit or short circuit in the room temperature sensor.
E2: Indicates open circuit or short circuit in the pipe temperature sensor.
E3: Indicates a refrigerant leak.
Please contact an authorized service centre if any of the above error
messages are shown.
E4: Indicates the water tank is full. Refer to WATER DRAIN.
If error code E4 persists, please contact an authorized service centre.
11