Sony PlayStationPortable Go Instruction Manual page 11

Using an access point
When using the PSP system's search function to select a wireless
™
network access point, access points that are not intended for
public use may be displayed. Only connect to a personal access
point that you are authorised to use, or one that is available
through a commercial wireless network or hotspot service. User is
responsible for all fees associated with wireless network access.
Use in other countries
Depending on the country, there are limitations on the use of
certain types of radio waves. In some cases, use of the PSP
system may lead to a fine or other penalty.
Handling and care of exterior surfaces
Follow the guidelines listed below to help avoid deterioration or
discolouration of the PSP system.
™
 Do not use solvents or other chemicals to clean the exterior
surface.
 Do not allow the system to remain in direct contact with rubber
or vinyl products for an extended period of time.
 Do not use a chemically-treated cleaning cloth to wipe off the
system.
Before using the analog stick
 Do not attempt to remove the analog stick from the system
front, as doing so will damage the system and may result in
injury.
 For best results, go to (Settings)
and then with the [System Information] screen displayed, rotate
the analog stick in a circular motion to adjust the analog stick's
range of movement.
Cleaning
For safety reasons, unplug the AC adaptor from the electrical
outlet and disconnect any other cables before cleaning the system.
Cleaning the exterior surface and LCD screen
Wipe gently with a soft cloth.
Cleaning the connectors
If the connectors on the PSP
become dirty, signals may not be sent or received properly. Also,
if the connector on the headphones becomes dirty, you may
experience noise or interruptions in sound. Wipe the connectors
™
with a dry, soft cloth to keep in clean condition.
Cases and coverings
When placing the PSP
turn off the power or put the system in sleep mode. Do not use the
system while it is in the case. Leaving the system on, or using it
while in a case or covering may cause overheating or may damage
the system.
(System Settings),
system or on the USB cable
™
system in a commercially available case,
™
Precautions
GB
11