Component Locations; Specifications - Whirlpool Washer Service Manual

FOR SERVICE TECHNICIAN'S USE ONLY

COMPONENT LOCATIONS

Drum Light
Assembly
Door Switch
(Location may vary
between models)
See Removing Front Panel
and Bulkhead, page 23, to access:
• Motor Assembly & Belt Switch
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
Figure 28 - Component locations.

SPECIFICATIONS

Voltage:
Amps:
Frequency:
Water Pressure:
Operating Temperature Range:
Dryer Height:
Dryer Width:
Dryer Depth:
DO NOT REMOVE OR
DRYER SPECIFICATIONS
240 VAC (200-260) Elect. Dryer, 2-phase, "optimized"
208 VAC (176-229) Elect. Dryer, 3-phase, "less optimized"
DESTROY
See Removing Top Panel, page 23, to access:
• User Interface (UI)
• Cycle Control Unit (CCU)
• Inlet Thermistor (Gas)
NOTE: Refer to Figure 20b, page 14,
for gas dryer component locations.
120 VAC (100-130) Gas Dryer
(ELECT) 30 Amp Service
(GAS) 15 Amp Service
58 to 62 Hz (60 Hz nominal)
20-120 PSI
40 to 105°F (5 to 40°C)
39 in. (99.1 cm)
27 in. (68.6 cm)
31 in. (78.7 cm)
See Removing Rear Panel,
page 23, to access:
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
• High Limit Thermostat
• Heater Assembly
PAGE 27