Panasonic KX-TG2224CB Operating Instructions Manual page 23

✷✸✸✿✤✦✪✦✤Z✮.❃ook ✥✦
To dial after confirming the
entered number
1
Enter a phone number.
3334444
Clear Pause
• If you misdial, press Clear . Enter
the correct number.
• If a pause is required for dialing,
press Pause where needed
(p. 40).
• To cancel, press [OFF] .
2
Press [ ] or [ ] .
3
To hang up, press [OFF] or
place the handset on the base
unit.
If noise interferes with the
conversation
Have the unit select a clearer
channel by doing one of the
following:
Press [ ] (Channel) if talking
using [ ] ,
press [ ] (Channel) if talking
using , or
[ ]
press CH , which is displayed when
you adjust receiver or speaker
volume (p. 24).
OR
Walk closer to the base unit.
To redial the last number
dialed
Press [ ] or [ ] , then press
[REDIAL] .
] ] _
Making Calls
To redial using the redial
list (Memory Redial)
The last 5 phone numbers dialed with
the handset are stored in the redial list.
1
Press [REDIAL].
333-4444
Exit Erase
• The last number dialed is
displayed.
2
Scroll to the desired number by
pressing [ ] or [ ].
• You can also scroll through the list
by pressing [REDIAL].
• To exit the list, press [OFF] or
Exit.
3
Press or [ ].
[ ]
• To erase an item, scroll to the
desired item then press Erase .
• If " No items stored " is displayed,
the list is empty.
To put a call on hold
Press Hold during a conversation.
Talk
00-00-08
(VE)
• "Hold" is displayed.
• To page the base unit while holding,
press Intercom (Intercom hold).
To return to the call, press [
[ ] .
• If another phone is connected on the
same line, you can also return to the
call by lifting its handset.
• If a call is kept holding for 6 minutes,
an alarm tone will start to sound.
After 4 additional minutes on hold, the
call will be disconnected.
• The alarm volume corresponds to the
ringer volume level (p. 17). If the
ringer is OFF, the alarm will sound at
the LOW level.
Hold
] or
23