Remote Relay; Operate The Relay Manually; Operate The Relay By Calling It Up - Ontech GSM Mini 9009 User Manual

Remote relay

With this function you can call up or send SMS to the unit and operate the on or
more slave units 230V/16A relay individually.
Insert the unit in the wall power socket you wish. Put the power contact of the
device you want to operate in the unit power socket.

Operate the relay manually

You can make the relay switch by pressing the button on the unit. When the relay is
on, the red lamp is lit and when the relay is off, the red lamp is not lit.

Operate the relay by calling it up

7. Call up the unit. Be sure you use tone mode on the telephone.
8. The unit answers with a beep.
9. Press your PIN-code and then #.
Example: 1234#
If the PIN-code is correct the unit replies with a beep. If it is not correct the
call is disconnected. Call again and try.
10. Turn on the relay by pressing the following buttons:
1*N# N is the ID of the unit.
The unit replies with a beep. Hang up the receiver. If the unit replies with
two beeps, try again.
11. Turn off the relay by pressing the following buttons:
0*N# N is the ID of the unit.
The unit replies with a beep. Hang up the receiver. If the unit replies with
two beeps, try again.
12. Turn on the relay with timer function
The relay can be turned on and you can set the number of hours you want
it on before it switches to off (between 1 and 99 h). Press the following
buttons:
1*N*T# (T= the number of hours you want the relay to be in on mode, N is
the ID of the unit.).
The unit replies with a beep. Hang up the receiver. If the unit replies with
two beeps, try again.
-23-