Setting date and time (continued)
Changing the date and time display style
SETUP
DISPLAY
DATE/TIME
DATE FORMAT
FORMAT CARD
QUICK START
SETUP
∫ About date/time
≥ The date and time function are driven by a built-in lithium battery.
≥ Make sure to check the time before recording because the built-in clock is not very accurate.
≥ If [0] or [– –] is indicated when this unit is turned on, then the built-in lithium battery
runs down. After charging the battery using the steps below, set the clock.
∫ Charging the built-in battery for the date
≥ Connect the AC adaptor to this unit or place the battery on this unit, and the built-in
lithium battery will be recharged. Leave this unit as is for approx. 24 hours, and the
battery will save the date and time for approx. 6 months. (Even if the [ON/OFF]
switch is set to [OFF], the battery is still being recharged.)
Adjusting LCD monitor
Adjusting the brightness and colour level of the LCD monitor
1
SETUP
POWER SAVE
BEEP SOUND
LCD AI
LCD SET
INITIAL SET
SETUP
2
LCD SET
SETUP
≥ These settings will not affect the images actually recorded.
30
VQT0T60
OFF
D/T
DATE
EXIT
ENTER
MENU
[DATE]
15. 12. 2005
YES
NO
EXIT
ENTER
MENU
SET
ENTER
EXIT
MENU
Press the menu button, select
1/3
[
SETUP]#[
the cursor button to select the desired
display style. (P27)
≥ The date and time display can also be
changed by pressing the [DATE/TIME] button
on the remote control.
[D/T]
15:42
15. 12. 2005
Press the menu button, then use the
2/3
cursor button to set
[
SETUP]#[
(P27)
Press the cursor button up or down to
select the item to be adjusted. Then,
press the cursor button left or right to
make the adjustment.
The bar display moves.
–
–
DATE/TIME], then use
[OFF]
LCD SET]#[YES].
: Brightness of the LCD monitor
: Colour level of the LCD monitor