Table Of Contents; General - Sony TCM-450DV Service Manual

TCM-450DV

TABLE OF CONTENTS

1. GENERAL
................................................................... 2
2. DISASSEMBLY
.......................................................... 3
2-1. Cabinet (Rear) ......................................................... 3
2-2. Main Board ............................................................. 4
2-3. Mechanism Deck (MT-450-175) ............................. 4
2-4. Belt (Counter), Belt (Cap)S,
M901 (Capstan/Reel Motor), HRP901
(REC/PB Head), HE901 (ERASE HEAD) ............. 5
2-5. Cassette Lid Assy, Led Board ................................. 5
3. MECHANICAL ADJUSTMENTS
4. ELECTRICAL ADJUSTMENTS
5. DIAGRAMS
5-1. Block Diagrams ....................................................... 7
5-2. Printed Wiring Board -MAIN Section (Side A) - .. 8
Printed Wiring Board -MAIN Section (Side B) - .. 9
5-3. Schematic Diagram -MAIN Section (1/2) - ........... 10
5-4. Schematic Diagram -MAIN Section (2/2) - ........... 11
5-5. IC BLOCK DIAGRAMS ........................................ 12
6. EXPLODED VIEWS
6-1. Cassette Lid, Cabinet (Rear) Section ...................... 13
6-2. Cabinet (Front) Section ........................................... 14
6-3. Mechanism Deck Section-1 (MT-450-175) ............ 15
6-4. Mechanism Deck Section-2 (MT-450-175) ............ 16
7. ELECTRICAL PARTS LIST
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
2
....................... 6
......................... 6
m REW/REVIEW
PAUSE .
PLAY MODE*
................................ 17
SECTION 1

GENERAL

VOR
Microphone
z REC
x STOP
REC TIME/
* The button/jack has a tactile dot.
This section is extracted from
instruction manual.
Tape counter
reset button
TAPE COUNTER
EAR
MIC (PLUG
IN POWER)*
REC/BATT
DC IN 3V