SoftBank 104SH User Manual page 17

USB Charging
Connect handset to a PC with Micro USB Cable.
・Power on handset and PC first.
・To use Fast transfer mode, install USB Cable driver on the
PC beforehand.
・Battery may not charge or charge slowly depending on PC
status/environment.
Insert Micro USB Cable into External Device Port
・Use notch below Port Cover to open it. Gently fold back
Port Cover using hinge; do not pull/twist Port Cover.
・There are two types of connector for supported Micro
USB Cable. Confirm connector type (varies by product)
beforehand.
・Insert Micro USB Connector with tabs (○) on slot side
facing up.
Insert Micro USB Cable into PC USB port
Notification Lamp illuminates while charging.
・Notification Lamp goes out when Battery is full. Remove
Micro USB Cable and close Port Cover.
Micro USB Connector
Upon connecting Micro USB Connector (connector of Micro
USB Charging Adapter, Micro USB Cable, etc.) to External
Device Port, confirm type and orientation of Micro USB
Connector, then insert it with tabs (slot side) facing up.
・Do not insert Micro USB Connector in the wrong
orientation; External Device Port may be damaged.
Slot
Tabs
External Device Port
The figure above is based on Micro USB Charging Adapter.
Charging Precautions
Handling Cords
Do not pull, bend, or twist cord.
Handling External Device Port Cover
Remember these points when closing Port Cover:
・Close Port Cover firmly. Debris trapped between gasket
and base may expose handset to liquid/dust.
・Do not try to close Port Cover with hinge extended; may
deform Port Cover and affect water/dust resistance.
Important USB Charging Note
Handset may power on automatically when connected to a
PC with Micro USB Cable; avoid connection aboard aircraft
or in hospitals, etc. where handset use is prohibited.
15