Configure The Switch Using Cli - TP-Link JETStream T2700G-28TQ Installation Manual

6.2 Configure the Switch Using CLI

You can log on to the switch and access the CLI by the following two methods:
Log on to the switch by the console port on the switch.
■
Log on to the switch remotely by a Telnet or SSH connection through an Ethernet
■
port.
Logon by a Console Port
■
To log on to the switch by the console port on the switch, please take the following
steps:
1. Connect the PCs or Terminals to the console port on the switch by a provided cable.
2. Click Start→All Programs→Accessories→Communications→Hyper Terminal to open
the Hyper Terminal as the following figure shown.
Figure 6-3 Main Page of the Switch
Figure 6-4 Open Hyper Terminal
Stackable L2+/L3 Managed Switch
Configuration
24