Stackable L2+/L3 Managed Switch
Chapter 3 Installation
3.1 Installing the Switch on a Desktop
3.2 Installing the Switch Into a 19-inch Rack
09
Installation
To install the switch on the desktop, please follow the steps below:
1. Set the switch on a flat surface strong enough to support the entire weight of the
device with all fittings.
2. Remove the adhesive backing papers from the rubber feet.
3. Turnover the switch and attach the supplied rubber feet to the recessed areas on
the bottom at each corner of the switch.
To install the switch in an EIA standard-sized, 19-inch rack, follow the instructions
described below:
1. Check the grounding and stability of the rack.
2. Secure the supplied rack-mounting brackets to each side of the switch with supplied
screws, as illustrated in the following figure.
Figure 3-1 Desktop Installation
Figure 3-2 Bracket Installation
Feet
Bottom of the Device
Notch
Rack-mounting Bracket
Screw