Table of Contents
Advertisement
Section 1: Assembly and Setup
Blade Offset Cylinder
Refer to Figure 1-6:
IMPORTANT: Attach cylinder base to the front hitch
lug. The cylinder base will interfere with the main
frame if attached to the rear lug.
Assemble hydraulic hoses to the hydraulic cylinder
before placing cylinder on the blade.
1. Position hydraulic cylinder with ports on top. Install
two 90 degree elbows into the cylinder ports and
tighten as needed.
2. Screw 96" long hydraulic hoses into the elbows and
tighten. Use 101" long hydraulic hoses when sing a
Quick Hitch.
3. Thread adapter fittings to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs located on either
side of the Rear Blade with clevis pins. Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
5. Secure clevis pins with hair pin cotters.
6. Route hoses through hose brackets located on top of
the main frame and on the right side of the front hitch.
Connect hoses to tractor's hydraulic system.
Blade Tilting
15004
8
RB4596, RB45108 & RB5596 Rear Blade 301-133M
Table of Contents
Blade Tilting Cylinder
Refer to Figure 1-6:
IMPORTANT: Attach cylinder base to the upper
mounting lug.
Assemble hydraulic hoses to the hydraulic cylinder
before placing cylinder on the blade.
1. Position hydraulic cylinder with ports on top. Install
two 90 degree elbows into the cylinder ports and
tighten as needed.
2. Screw 114" long hydraulic hoses into the elbows and
tighten. Use 125" long hydraulic hoses when sing a
Quick Hitch.
3. Thread adapter fittings to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs located on the
back of the Rear Blade with clevis pins. Make sure
hydraulic ports are positioned facing forward and the
cylinder base in positioned up as shown.
5. Secure clevis pins with hair pin cotters.
6. Route hoses through hose brackets located on top of
the main frame and on the right side of the front hitch.
Connect hoses to tractor's hydraulic system.
Hydraulic Tilt and Offset Assembly
Figure 1-6
Blade Angling
Land Pride
5/21/07
Advertisement
Table of Contents
