Table of Contents
Advertisement
Section 1: Assembly and Set-Up
Front Guard Assembly
!
DANGER
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety guards is
strongly recommended when cutting along highways or in
areas where people may be present.
!
WARNING
Not all objects will be stopped by safety guards. Therefore, use
extreme caution when cutting in areas where people may be
present. It is best to operate the cutter when no one is near-by.
Stop blade rotation if someone is within several hundred feet!
Front Rubber Guard Installation
Refer to Figure 1-9:
1. Install center rubber guard (#5) with 3/8" x 1" long
carriage bolts (#4). Secure with 3/8" flange nuts (#3).
2. Install left and right side rubber guards (#2) with
3/8" x 1" long carriage bolts (#4). Secure with
3/8" flange nuts (#3).
3. Tighten all 3/8" flange nuts (#2) to 31 ft-lbs as
indicated in the "Torque Values Chart" on page 34.
Front Chain Guard Installation (Optional)
Refer to Figure 1-10:
1. Install center chain guard (#1) with 3/8" x 1" long
carriage bolts (#4). Secure with 3/8" flange nuts (#3).
2. Install left and right chain guards (#2) with 3/8" x 1"
long carriage bolts (#4). Secure with 3/8" flange nuts
(#3).
3. Tighten all 3/8" flange nuts (#2) to 31 ft-lbs as
indicated in the "Torque Values Chart" on page 34.
16
RCR1884 Series Rotary Cutter 312-880M
Table of Contents
24656
24657
Front Rubber Guard
Figure 1-9
Front Chain Guard
Figure 1-10
2/03/12
Advertisement
Table of Contents
