Advertisement
ASSEMBLY INSTRUCTIONS
Before assembling your Folbot, take time to familiarize yourself with all the parts and the terminology
used. You should find the following contents when you unpack your boat for the first time.
SHORT BAG CONTENTS (pictured above)
5 crossframes —
Anodized black and numbered 1-S, 2-S,
3-S, 4-S and 5-S.
1 cockpit nose — Made of black urethane and temporarily attached to crossframe 2-S.
1 boatskin
Note how the boatskin is folded so you can put it back correctly when disassembled.
—
1 seat — Made of closed-cell mini-foam. The bottom and back are joined together.
LONG BAG CONTENTS (pictured above right, listed left to right)
2 sections of bottom keel
The bow (front) section has the numbers 1, 2 and 3 printed on the black
—
nylon plates. The stern (back) section has the numbers 4 and 5.
4 sections of side frame —
Identified by the words right bow, right stern, left bow and left stern.
1 rear washboard —
About 14" long, shaped in a shallow "V".
2 washboards —
Each piece (one left, one right) has two black knobs attached.
2 keel ends, including lower longerons and deck struts —
Identified by the words bow and stern.
There are two sets of longerons (two parts each, shockcorded together) and a deck strut (two parts)
attached to each black nylon keel end.
Page 4 of 10
Advertisement
