Table of Contents
Advertisement
Section 4: Maintenance and Lubrication
20772
24
DM3705, DM3706, and DM3707 Series Disc Mowers 327-083M
Table of Contents
Cutter Bar
Check oil level in cutter bar by removing filler level plug with
cutter bar in transport position. (Fill/Level plug is located
between first and second discs on DM3705 and between
second and third discs on DM3706 and DM3707.) Add oil if
level is low.
IMPORTANT: The recommended oil quantity should
not be exceeded. Results of overfilling will be
overheating with potential for severe damage to
cutterbar. Mower should be level and cutter bar vertical
when checking oil. Be sure to let cutting bar set in
vertical position for a few minutes before checking to
allow time for oil to flow to bottom of bar.
Type of Lubrication: SAE 90 GL4 (EP) gear lube
Quantity = Fill until level with filler level plug hole. (See
important note above.)
Frame Pivot Point
Type of Lubrication: Multi-purpose Grease
21032
Hitch Pivot Point
Type of Lubrication: Multi-purpose Grease
21032
As
Required
20
Hours
20
Hours
9/15/06
Advertisement
Table of Contents
