Config Setting - Ralink WLAN USB Adapter for 802.11b/g User Manual

Config Setting

User can set and display detailed Soft AP information in this dialog box.
Items
SSID
Wireless Mode
Country Region Code
Beacon (ms)
TX Power
Idle Time
Wireless Protection
Channel
TX Rate
Information
AP name of user type. The user also can select [Use Mac Address] to display
it. System default is SoftAP-XX (XX is last two numbers of MAC address).
Select wireless mode. 2.4G and 5G are supported. System default is 2.4G.
( 802.11 B/G/N mix selection item only exists for B/G/N adapter )
The Country Region Code allows the user to specify the available channel list
based on their country's regulations.
The time span between two successive4 beacons. System default is 100 ms.
The transmitting power of Soft AP. System default is 100%.
The allowed idle time before proceeding with the authentication. The default
is 300.
The user can chose from Auto, on, and off. System default is auto. (802.11n
wireless cards don't support wireless protection.)
a. Auto: STA will dynamically change according to the AP.
b. On: Always send frames with protection.
c. Off: Always send frames without protection.
Select the AP's operating channel manually. System default is channel 1.
The transmitting rate. The default is auto. (802.11n wireless cards don't
support TxRate.)