Advertisement
Removing the current mode source
selector board assembly and rear
terminal panel
Prior to performing the following procedure, remove
the metal cover and the rear panel.
1.
Remove the six screws W attaching the RCA pins on
the current mode source selector board assembly.
Then, the current mode source selector board can
be removed.
2.
Remove the four screws X attaching the cannon
connector on the signal processing board.
3.
Then, the rear terminal panel can be removed.
Removing the signal processing board
assembly
Prior to performing the following procedure, remove
the metal cover and the rear panel.
1.
Remove the current mode source selector board
assembly and the rear terminal panel.
2.
Remove the five screws Y attaching the signal
processing board assembly.
3.
Remove the connectors CN251 and CN252.
Removing the power switch board
assembly
Prior to performing the following procedure, remove
the metal cover.
1.
Remove the four screws Z attaching the power
switch board assembly.
2.
Remove the cable connecting to the transformer.
(See Fig. 16)
Rear terminal panel
(See Fig. 17)
Y
Signal processing board
(See Fig. 18)
Z
Current mode source selector board assembly
X
Fig.16
Y
Fig.17
Fig.18
AX-M9000
W
Power
switch
board
1-7
Advertisement
