Advertisement
Disassembly method
Removing the metal cover (See Fig. 1)
1.
Remove the three screws A attaching the metal
cover on the back of the body.
2.
Remove the four screws B attaching the metal cover
on both sides of the body using a hexagon wrench.
3.
Draw the metal cover upward from the behind while
pulling the both sides of the lower part of the metal
cover outward.
Removing the front panel assembly
(See Fig. 2 to 5)
Prior to performing the following procedure, remove
the metal cover.
1.
Remove the six screws C attaching the top plate
using a hexagon wrench.
2.
Remove the six screws D and tow screws D'
attaching the front panel assembly from the back of
the body.
3.
Remove the four screws E attaching the front panel
assembly from the upper part of the body.
4.
Remove the four screws F attaching the front panel
assembly on both sides of the body.
5.
Disconnect the harness from the connectors CN601,
CN602, CN603, CN604 and CN605 of the system
control board assembly.
6.
Remove the screw G attaching the earth wire.
* The front panel assembly of this machine
comprises the three sets - the front panel
(left), front panel (right) and sub-panel (center).
Front panel assembly
D
D'
Fig.3
AX-M9000
Metal cover
B
2
A
B
2
Fig.1
C
Top plate
Fig.2
E
Front panel
F
F
2
assembly
2
Fig.4
G
System control board assembly
Earth wire
CN602
CN601
CN605
CN604
CN603
Fig.5
1-3
Advertisement
