Preparing Your Boat; Binding - Helios Rivos Operating Instructions Manual

Slideyourfullychargeddrivebatteryintothe
hull and strap in place with the hook and loop
fasteners.
Placethetophatchinpositionandrotatethe
latch to secure.
The Rivos comes already bound. If however you need to
re-bindfollowtheseinstructions.
WiththetransmitterswitchedOFF
Plug in the bind jumper plug (included in your spare
parts bag) into the CH3/Bind Slot on the Receiver. Plug
thebatteryintotheelectronicspeedcontrol(ESC)The
redLEDonthereceiverwillblinkrapidlyindicatingthatit
is in bind mode.
Pressandholdthebindbuttononthetransmitterwhile
sliding the power switch ON.
Releasethebuttonafterthetransmitterpowersup.The
transmitterwillmakeabeepingsoundtoindicatethatit
isinbindmodeWithinapproximately5secondstheRivos
willlinkandtherudderwillcenterandLEDwillgosolid.
Remove the bind plug from the reciever. You are ready to run.

Preparing your Boat

Binding

6
Withyourtransmitterturnedon,plugthe
drivebatteryintothespeedcontrol.
Important
Do not arm the boat motor until you have
placed the boat into the water.
Once in the water, arm the motor by
pushing the throttle trigger forward and
then pulling it to the rear.
Bind Plug
Transmitter Bind
Press and Hold
Insert
Button