Electrolux FREEZER / REFRIGERATOR Use And Care Manual page 10

10 Removing The Doors
3 Detach the water tube from the
connector located below the freezer
door. The connector releases when you
press and hold its outer sleeve inward.
With the sleeve held in this position, the
tube can be removed.
Closer
Hinge
Adjustable Hinge (some models)
Non-Adjusting Hinge (some models)
4 Remove the screws from the top hinge
and pull the multi-wire cable through it.
Lift the door off of the bottom hinge.
5 Remove the two bottom hinge screws
and hinge if necessary.
6 Lay the door on its side to avoid damage
to the water tube extending from the
bottom hinge.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and
cause personal injury.
Door
Water
Line
Pin
Tubing
Hinge
Screws
Assembly
Door
Water
Line
Tubing
Hinge
Assembly Screws
To reinstall the freezer door, reverse the above
steps.
Once both doors are in place, ensure they are
aligned with each other and level (Please see
"To level the doors using the lower hinge" for
models with adjustable lower hinges or "To
level the cabinet using the front rollers" for
models with the non-adjustable lower hinges
in the "Installation" section.), then replace the
top hinge cover.