Mounting And Connecting Tips - XTZ Master M2 Owner's Manual

MOUNTING ALTERNATIVES
CONNECTING USING THE
CORRECT PHASE
OVERLOAD
THE INITIAL PLAYING TIME

MOUNTING AND CONNECTING TIPS

Normally the Master M2 is placed standing by a wall. The wall behind and the
wall beside the loudspeaker have influence on both the bass level and the bass
characteristics, so please be patient and try different distances to the rear and
side walls.
Always connect using the correct phase, from the +-pole on the amplifier to the
+-pole on the loudspeaker and corresponding for minus (-).
At high load during extensive time periods, there is always the risk of overloading
the driver and amplifier.
It takes about 50 to 100 hour of initial playing time, for the driver to sound
optimal. During this time, the speaker may be used normally.
9
If you by accident connect the
other way, there is no risk of
damage. However, the sound
will not be correct, especially
in the lower frequencies.
All loudspeakers have a
limited patience for high
power, so be careful not to
play extremely loud and not
to increase treble or bass
settings to much.
By increasing the bass or
treble from 0 to max you will
increase the power by about
16 times.