Throttle Trigger And Steering Wheel Spring Tension Adjustment; Steering Wheel Travel Adjustment; Wrist Strap Anchor - Sanwa MT-4 Operating Manual

aDjUSTMEnTS anD OPTiOnS

THROTTLE TRiggER anD STEERing wHEEL SPRing TEnSiOn aDjUSTMEnT

The spring tension of the throttle trigger and steering wheel can be adjusted to best suit the user. Some users may prefer the
throttle trigger and/or steering wheel to feel 'firmer' and some users may prefer them to feel 'softer'. It all depends on your
personal preference.
To adjust the throttle trigger spring tension, follow the step below:
1) To increase the spring tension of the throttle trigger (firmer), use a 1.5mm hex
wrench to turn the Throttle Trigger Tension Adjustment Screw (A) clockwise. To
decrease the spring tension of the throttle trigger (looser), turn the Throttle Trigger
Tension Adjustment Screw counter-clockwise.
To adjust the steering wheel spring tension, follow the step below:
1) To increase the spring tension of the steering wheel (firmer), use a 1.5mm hex
wrench to turn the Steering Wheel Tension Adjustment Screw (A) clockwise.
To decrease the spring tension of the steering wheel (looser), turn the Steering
Wheel Tension Adjustment Screw counter-clockwise.

STEERing wHEEL TRavEL aDjUSTMEnT

The maximum right and left travel of the steering wheel can be adjusted to best suit the feel of the steering wheel and your driving
style. Some drivers prefer to limit the travel of the steering wheel as it makes them feel more 'connected' to their model.
To adjust the maximum travel of the steering wheel, follow the steps below:
1) Remove the foam steering wheel grip from the steering wheel by firmly pulling it straight off.
2) To limit the maximum travel of the steering wheel, use a 1.5mm hex wrench to turn both grub
screws (A) clockwise equally the desired amount. To maximize the travel of the steering wheel,
turn both grub screws counter-clockwise equally the desired amount.
After making steering wheel travel adjustments, you must use the Variable Rate Adjustment
function to ensure your steering servo travel limits are equal. For more information, see the
Variable Rate Adjustment section on page 71.
Limiting the maximum travel of the steering wheel will increase the sensitivity of the steering.
We recommend setting negative Exponential to soften the control feel around Neutral. For
more information, see the Exponential and ARC Adjustment section on pages 23 ~ 25.

wRiST STRaP ancHOR

A wrist strap anchor is included that can be installed onto the transmitter to facilitate the use of a wrist strap (not included).
To install the wrist strap anchor, follow the steps below:
1) Remove the self-tapping screw (A) from the transmitter, using a # 1 philips
head screwdriver.
2) Slide the wrist strap anchor into the mounting slot in the back of the transmitter,
then reinstall and tighten the self-tapping screw.
When installing the wrist strap anchor, note its orientation. The U-Shaped
groove in the base of the wrist strap anchor should be pointing down.
Page 15
A
A
B
A