Mazda CX-9 2007 Installation Instructions Manual page 7

13
BODY CONTROL MODULE CONNECTIONS
1. LOCATE THE 30-PIN, 6-PIN, 16-PIN AND THE 24-PIN CONNECTORS AT
THE BODY CONTROL MODULE LOCATED IN THE DRIVER'S KICK PANEL.
(FIGURE O)
14
HORN CONNECTION
1. LOCATE THE 30-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER'S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1"-2" OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. (
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP , CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & P FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE'S HORN WIRE
GREEN/RED
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
15
DOOR TRIGGER CONNECTION
1. LOCATE THE 6-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER'S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1"-2" OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. (
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP , CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & Q FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE'S DOOR TRIGGER WIRE
YELLOW/RED
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
16-PIN Connector
CAUTION: BE EXTREMELY CAREFUL
!
CAUTION: BE EXTREMELY CAREFUL
!
30-PIN Connector
#0940-01C
6-PIN Connector
#0940-01D
#0940-01E
FIGURE P
SECURITY HARNESS WIRE
FIGURE Q
SECURITY HARNESS WIRE
7
24-PIN Connector
#0940-01F
FIGURE O
Connector #0940-01C
VIEW FROM HARNESS SIDE
GREEN/RED
Connector #0940-01D
VIEW FROM HARNESS SIDE
YELLOW/RED
1031989 Rev. A 5/07