Power Saving Test; Dcc 1/2B Test - NEC MultiSync V920 Service Manual

Color monitor
Hide thumbs

Advertisement

Table of Contents
(C) Contrast control set to Max and brightness control set to the center, adjust R.G.B. GAIN
standard as below
9300K x = 0.283 + 0.010
y = 0.297 + 0.010
Y = 155 + 5 cd/m²
7500K
x = 0.300 + 0.010
y = 0.315 + 0.010
Y = 155 + 5 cd/m²
6500K
x = 0.315 + 0.010
y = 0.325 + 0.010
Y = 155 + 5 cd/m²
(D) PATTERN: FULL WHITE 9300K.
(E) If they are out of spec, adjust to following:
BRIGHTNESS: Back raster is 0.2 cd/m² position
CONTRAST MAX: (MAX-5 digit )~(MAX)
Adjust R/G/B gain to be 9300K color due to about spec.
(F) When adjust 6500K and 7500K color¡Akeep brightness and contrast max position to (E)
condition. Adjust R/G/B/ GAIN to be 6500K color due to about spec..
(G) Adjustment: Brightness control and contrast control set to Max, adjust VR303 to
Y=29~31FT-L(103+3cd/m²)

(17) POWER SAVING Test:

(A) MODE: 60kHz 1024*768(75)
(B) PATTERN: ANY PATTERN.
(C) Adjustment:
a. It should be into suspend mode when signal quit after 5 sec.2
be<15W. Check the LED color :Orange.
b. It should be into power off mode when into suspend mode after 3sec.and the power
output must be<5W. Check the LED color :Orange
c. Transfer the signal and check the screen is normal. Check the LED color :Green
(18) DDC 1/2B Test:
(A) MODE: Any MODE.
(B) PATTERN: Any PATTERN.
(C) Scan bar code label and apply serial NO. to EDID Data.
10
nd
the power output must

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for NEC MultiSync V920

  Related Manuals for NEC MultiSync V920

This manual is also suitable for:

Accusync 90Multisync v921-1Accusync 50mMultisync 95

Table of Contents