Table of Contents
Advertisement
Installation
Pressure Testing
(
Have a trained pool professional perform all pressure tests.)
Before pressure testing, make the following safety checks:
•
Check all clamps, bolts, lids, and system accessories prior to testing.
•
Release all air in system before testing.
•
Tighten trap lid to 4.1 kg-m torque for testing.
•
Water pressure for test must be less than 172kPa (25 PSI).
•
Water temperature for test must be less than 35
•
Limit test to 24 hours. After test, visually check system to be sure it
is ready for operation. Remove trap lid and retighten hand tight only.
Fire and burn hazard. Modern motors run at high tempera-
tures. To reduce risk of fire, do not allow leaves, debris, or
foreign matter to collect around the pump motor. To avoid
burns when handling the motor, let it cool for at least 20
minutes before trying to work on it. A thermal overload switch
protects the motor from heat damage during operation.
MaxEPro_OwnersManual_2012
Monday, 17 December 2012 10:03:45 AM
Incorrectly installed or tested
equipment may fail, causing severe
injury or property damage.
Read and follow instructions in owner's manual when
installing and operating equipment. Have a trained pool
professional perform all pressure tests.
1.
Do not connect system to a high pressure or city
water system.
2.
Use equipment only in a pool or spa installation.
3.
Install pump with at least 2 hydraulically balanced
main drains equipped with correctly installed,
screw-fastened, anti-entrapment certified covers
according to local regulations.
3.
Trapped air in system can cause explosion. Ensure
all air is out of system before operating or testing
equipment.
3
°
C.
Advertisement
Table of Contents
