Changing Motor Brushes - Samurai Industrial Floor Stripper Operator's Manual

B. General Service Procedures cont'd ...

2. Changing Motor Brushes

1. Remove and inspect protector covers for motor brushes from either side of motor. (Fig.42)
2. Unscrew brush caps. Note: Brush caps are made of a soft material. Take care when removing to
not damage any part. Reorder caps if damaged before proceeding further. (Fig.43)
3. Remove brush and replace.
4. Replace brush caps and protector caps, taking care not to damage any parts.
Fig.42: Remove
and inspect
protector covers.
3. Changing Nylon Wheels
1. Remove and inspect axle bolt for nylon wheels. (Fig.44)
2. Replace worn wheels, taking care to insert wheels in order as shown. (Fig.45)
3. Replace nut, tighten until bolt is secure. DO NOT OVER TIGHTEN. WHEELS MUST SPIN FREELY.
Maintenanace Procedures cont'd ...
Fig.44: Remove and
inspect axle bolt.
Technical Support Hotline
c/o Technical Service
Uniquip Canada Inc.
SAMURAI North American Authorized Dealer
English Service
T : 1-888-332-4012
F : 1-866-567-0956
Fig.45: Order of nylon
wheels for re-installation.
www.uniquip.ca
French Service
T : 1-800-332-4012
F : 1-866-825-2221
20
Fig.43: Carefully
remove brush caps.