C. Replacing All The Bushings, Washers And Bolts - Samurai Industrial Floor Stripper Operator's Manual

19
Maintenanace Procedures cont'd ...
B. General Service Procedures cont'd ...
1.Changing the bushings for the SAMURAI Floor Stripper cont'd ...

C. Replacing all the bushings, washers and bolts

1. Remove and inspect inner bushings set in the 4 bolt holes inside the top enclosure. Discard and
replace with new bushings as needed.
2. Replace inner bushings in each of the 4 bolt holes on both sides of the vibrating plate.
3. Turn vibrating plate over, bottom side up. Stack 1 rubber bushing, followed by 1 metal washer over
each of the 4 bolt holes. (Fig.34)
4. Insert bolt through each hole as shown. (Fig.35).
5. Turn vibrating plate over, top side up. (Fig.36) Slide large rubber bushings over each bolt as shown.
(Fig.37)
6. Align bolts to holes on top enclosure as shown and re-attach vibrating plate to the main unit. (Fig.38)
7. Turn unit right side up. (Fig.39)
8. Replace rubber bushings, metal washers (Fig.40) and cap nuts over each bolt. Check that all 4 bolts
are of even length. Use cap nuts to fi nely adjust length as needed. NEVER REPLACE CAP NUTS
WITH STANDARD NUTS.
9. Apply Loctite to cap nuts as needed. Tighten each nut as shown. (Fig.41)
10. Replace bottom enclosure plate and bolt to machine.
Fig.34:
Replace
washers and
bushings
Fig.35:
Insert bolts
through
vibrating
plate.
Fig.39: Main unit with vibrating plate.
Fig.37: Slide large rubber
Fig.36: Vibrating bushings as shown.
plate, right side up.
Fig.40: Replacing washers and
bushing to top enclosure.
Fig.38: Align bolts on vibrating
plate to holes on top enclosure.
Fig.41: Tighten nut caps.