Feligan 1500 Instruction Manual page 18

mA at a voltage of 5V DC.
Once used, pull slightly towards you and then release the cable, accompanying it during rewinding.
The retractable cables have a maximum length of 65cm.
When the cable length reaches its maximum, a white sign can be seen on the cable. Do not pull out
further. Otherwise, the cable may be damaged.
To ensure a long life of retractable cables, always accompany the movement of retraction of the
cables.
Use of USB ports
Connect your equipment to USB ports of the multi-charger to power it.
Each channel USB delivers up to 1000 mA at a voltage of 5V DC.
Use of Universal and Italian high-voltage sockets
The system has two universal sockets on the front and one "Italian-type" socket on the back.
The universal sockets are designed for connecting plugs from almost every country in the world
(Italian, European, American, Japanese, German, English, etc.).
Insert the plugs in the universal sockets horizontally.
Most Common Problems
The Multi-Charger Feligan® is on, but certain devices are not charged correctly.
The Multi-Charger Feligan is a high-power device that can load up to 8 devices at the time, 6
connected to retractable connectors and 2 to USB ports. This applies whether the connected devices
meet the standard USB and absorb less than 500mA each. The charger is even able to feed loads that
exceed this limit, up to a maximum of 1000mA per channel. If some or all of the devices absorb more
than 500mA, it is possible that some equipment is not properly fed.
Disconnect all devices and try again.
1500
The Feligan® is switched-on, but the blue LED does not light
Check that power limits of the device have not been exceeded, so that the safety fuse on the back
panel blows to avoid any risks of exceeding current limits of the multi-charger. If the fuse is damaged,
replace it with an equal. The characteristics of the fuse can be found on the label located at the back
of the Feligan® 1500, as well as on the fuse. To replace the fuse, disconnect the device from main
voltage, unscrew the fuse with a flat screwdriver, remove fuse, replace it with an equal and
reassemble.
2000 hk
The Feligan® is powered, but the blue LED does not light
Place wireless anti-theft key upon the edge of the device, to resume functioning.
If activation with anti-theft key has not succeed, check that power limits of the device have not been
exceeded, so that the safety fuse blows on the back panel to avoid any risk of exceeding current
limits of the device. If the fuse is damaged, replace it with an equal.
The characteristics of the fuse can be found on the label located at the back of the Feligan® 2000
hk, as well as on the fuse. To replace the fuse, disconnect the device from main voltage, unscrew the
fuse with a flat screwdriver, remove the fuse, replace it with an equal and reassemble.
WARNING!!!
18