Procom SN400TYLA Owner's Operation And Installation Manual

Procom SN400TYLA Owner's Operation And Installation Manual

Lp. & natural gas vent-free pedestal stove

Advertisement

OWNER ' S OPERATION AND INSTALLATION MANUAL
SN400TYLA SL400TYLA

Table of Contents

Safety Information Warnings.....................................2
Air For Combustion & Ventilation............................4
Installation....................................................................6
Blower Accessory ...................................................10
Operating Heater.....................................................12
Specifications.............................................................14
Troubleshooting........................................................15
Parts Breakdown & Parts List..................................18
Log Placing Instructions........................................22
WARNING: If the information in this
manual is not followed exactly, a f i r e o r
e x p l o s i o n
m a y
damage, personal injury, or loss of life.
WARNING: This is an unvented gas-fired
heater. It uses air (oxygen) f r o m t h e r o o m
i n
w h i c h
i t
i s installed. Provisions for
adequate combustion and ventilation air must
b e p r o v i d e d . R e f e r t o A i r F o r Combus-
tion and Ventilation section on page 4 of this
manual.
CINTINENTAL APPLIANCE INC
5 Musick
Irvine
CA 92618
TOLL-FREE NUMBER: 1-877-886-5989
r e s u l t causing property
4600 Highlands Parkway S.E
Suite # D/E
Smyrna, GA 30080
R
VENT-FREE PEDESTAL STOVE
Do not store, or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately
neighbor's phone. Follow the gas supplier's
instructions.
If
you
cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
q u a l i f i e d
i n s t a l l e r , s e r v i c e
supplier.
WA R N I N G :
adjustment, alteration, service or maintenance
can cause injury or property damage. Refer to
this manual for correct installation and opera-
tional procedures. For assistance or addi-
tional information consult a qualified installer,
service agency, or gas supplier.
This appliance may be installed in an aftermar-
ket*
permanently
(mobile) home, where not prohibited by local
codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This
appliance is not convertible for use with other
gases.
WATER VAPOR:A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vapor is a by-product of gas combustion. An
unvented room heater produces approximately one
(1)ounce(30ml) of water for every 1,000BTU's(.3KW's)
of gas input per hour, refer to page 6.
Installer : please leave these instructions with the
consumer
Consumer : please retain these instructions for
.
future use
*Aftermarket: Completion for sale, not for purpose of
resale, from the manufacturer.
LP. & NATURAL GAS
call
your gas supplier from a
a g e n c y
I m p r o p e r
i n s t a l l a t i o n ,
located, manufactured
o r
g a s

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SN400TYLA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Procom SN400TYLA

  • Page 1: Table Of Contents

    Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. SN400TYLA SL400TYLA cannot reach your gas supplier, call the fire department. Table of Contents Installation and service must be performed by a Safety Information Warnings........2...
  • Page 2: Safety Information Warnings

    SAFETY INFORMATION WARNINGS 4. This heater shall not be installed I M P O R TA N T: R e a d t h i s WARNING: Do not use a blower in a bedroom or bathroom. owner’s manual carefully and insert, heat exchanger insert, or other 5.
  • Page 3 SAFETY INFORMATION LOCAL CODES UNPACKING Continued lnstall and use heater with care. 1. Remove top inner pack. 15. Turn off and unplug heater and let F o l l o w a l l l o c a l c o d e s . I n t h e 2.
  • Page 4: Air For Combustion & Ventilation

    AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING: This heater shall not be installed in a confined space or The National Fuel Gas Code, ANS The air that leaks around doors and unusually tight construction unless Z223.1 defines a confined space as a windows may provide enough fresh provisions are provided for adequate...
  • Page 5 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas furnace Btu/Hr Gas water heater 30,000 Btu/Hr Vented gas heater Btu/Hr Vent-free heater 26,000 Btu/Hr Gas heater logs Btu/Hr Total 56,000 Btu/Hr...
  • Page 6: Installation

    INSTALLATION NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, you may run system's circulating Ceiling blower while using heater.
  • Page 7: Clearances To Combustibles

    CLEARANCES TO FOR LP Gas: COMBUSTIBLES The installer must supply an external regulator. The (Vent-Free Operation Only) external regulator will reduce incoming gas pressure. You Carefully follow the instructions below. This stove must reduce incoming gas pressure to between 11 to 14 is a freestanding unit designed to set directly inches of water.
  • Page 8 Pressure Testing Gas Supply WARNING: Never connect CAUTION: Avoid damage to Piping System Test Pressures In heater to private (non-utility) gas regulator. Hold gas regulator with Excess Of 1/2 PSIG(3.5kPa) wells. This gas is commonly known wrench when connecting into gas 1.
  • Page 9 2. Open gas supply tank valve. WARNING: Failure to position It is very important to install the logs 3. Make sure control knob of heater is the parts in accordance with these exactly as instructed. Do not modify in the OFF position. diagrams or failure to use only parts logs.
  • Page 10: Blower Accessory

    Blower Accessory Model PF06-YJLF-F compartment. no foreign objects in blower ACCESSORY PF06-YJLF-F wheel. Route ends of 4-wire power Tools required: Phillips screwdriver 15. Using the previously removed cord up from the lower control screws, mount blower assembly compartment through the plastic NOTICE: Shut off gas heater during to stove by reattaching the knock- bushing, then up to the upper...
  • Page 11 Figure 16-F -Routing Power Cord Figure 17F -Installing Blower Control Housing...
  • Page 12: Operating Heater

    LIGHTING Keep control knob pressed in for OPERATING HEATER 30 seconds after lighting pilot. INSTRUCTION FOR YOUR SAFETY After seconds. release READ BEFORE LIGHTING control knob. NOTICE: During initial operation of If control knob does not pop new heater, burning logs will give WARNING: If you do not out when released, contact a...
  • Page 13 THERMOSTAT CONTROL CLEANING BURNER OPERATION INJECTOR HOLDER AND The thermostat control knob can be PILOT AIR INLET HOLE set to any comfort level between HI The primary air inlet holes alow the proper amount of air to mix with the and LO.
  • Page 14: Specifications

    SPECIFICATIONS PARTS NOT UNDER WARRANTY Model Contact authorized dealers of this SN400TYLA/SL400TYLA product or Parts Central. If they can’t Btu(Variable) 20,000/40,000BTU/H supply original replacement part(s) Gas Type Propane/LP or NG call PRO-COM’s toll-free number on Ignition Piezo the front page.
  • Page 15: Troubleshooting

    TROUBLESHOOTING NOTE: All troubleshooting CAUTION: Never use a wire, WARNING: Only a qualified items are listed in order of needle, or similar object to service person should service operation. clean ODS/pilot. This can and repair heater. damage ODS/pilot unit. REMEDY POSSIBLE CAUSE OBSERVED PROBLEM Replace ignitor.
  • Page 16 TROUBLESHOOTING Continued REMEDY OBSERVED PROBLEM POSSIBLE CAUSE 1. Clean burner orifice (see Cleaning Burner(s) does not light after 1. Burner orifice is clogged. and Maintenance, page 13) or ODS/pilot is lit. 2. Burner orifice diameter is too replace burner orifice. small.
  • Page 17 TROUBLESHOOTING Continued WARNING: If you smell gas Shut off gas supply. Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
  • Page 18: Parts Breakdown & Parts List

    ILLUSTRATED PARTS BREAKDOWN SN400TYLA SL400TYLA 1 1 1 1 6 6 6 6...
  • Page 19 PARTS LIST SN400TYLA SL400TYLA n i t t o l t o l t a t t a t t e l t i n t a l t a l t e l t e l n i t...
  • Page 20 ILLUSTRATED PARTS BREAKDOWN SN400TYLA SL400TYLA...
  • Page 21 PARTS LIST SN400TYLA SL400TYLA...
  • Page 22: Log Placing Instructions

    LOG PLACING INSTRUCTIONS Follow the precedures below and the successive drawings to put log sets in place in the gas pedestal stove (indoor vent-free): Take out the paper liner(See DRAWING 1). DRAWING 1 Remove the screen from the appliance, then take out the log pack- age (See DRAWING 2).
  • Page 23: Manual

    INSTALLATION INSTRUCTIONS FOR S SERIES LOG SET SL400TYLA SN400TYLA The full set of logs for SN400TYLA and SL400TYLA(See Figure 1). Figure 2 Figure 1 STEP 1: Put log1, log2,log3 and log4 on the log bracket (angle iron) fixed by nuts. (See Figure 2).

This manual is also suitable for:

Sl400tyla

Table of Contents

Save PDF