ZDC ZAP-680 Quick Setup Manual

ZAP-680 802.11ac
Smart Access Point

Quick Setup Guide

This Quick Setup Guide provides step-by-
step instructions on how to set up your
ZAP-680 Smart Access Point.
completing the steps described in this
guide, you will be able to place the AP at
your site and provide wireless network
access to users.
PACKAGE CONTENTS
• ZAP-680 smart access point (1)
• DC power cord & PoE Injector (1)
• Mounting screws and brackets (2)
• A4 paper
HARDWARE OVERVIEW
Front View
LED Indicators on the Device
After
No LED State
1 PWR On
(Green)
2 SYS On
(Amber)
Off
3 WLAN Blinking
(Green)
Off
Blinking
(Amber
Off
SETUP REQUIREMENTS
Before installing your ZAP-680 access point, be
sure that you have the following:
• A computer running Windows 7, Vista, or XP
• A CAT5 UTP cable of required length
• One of the following power sources:
- IEEE 802.3at-compliant power over Ethernet
(PoE) source
- Power adapter came with the package
Note:
Description
If the AP is deployed with a AP controller, please
follow the section INSTALL THE AP to proceed.
Power is being
supplied to the
STEP 1: POWER ON THE AP
device
The Smart Access Point comes with a PoE
Device ready.
injector kit for connecting to power over the
Ethernet port
Ethernet port. The Smart Access Point
connected.
automatically turns on as soon as it is connected
Ethernet port not to a power source.
connected.
Cautions:
2.4G radio enabled
Use only the power adapter and PoE injector
or data being
that came with the wireless AP.
forwarded
1. Insert one end of an Ethernet cable to the
2.4G radio disabled
5G radio enabled or
2. Insert the other end to the LAN 1/PoE
data being
forwarded
3. Connect the power cord to the PoE
5G radio disabled
4. Connect the power plug to a wall socket.
P+DATA OUT port on the PoE injector.
port on the Smart Access Point.
injector.