Jøtul Cube 200 GG Instruction And Operation Manual page 7

3.6 Steel chimney
When using semi-insulated chimney: It is extremely important
that the shield is all the way down towards the top ring. (see
figure 2)
Fig. 2
3.7 Ceiling
Make sure the room where the Jøtul Cube is to be placed has a
ceiling height of at least 2300 mm.
3.8 Chimney and flue pipe
• The stove must be connected to a chimney and flue pipe
approved for solid fuel fireplaces with flue gas temperatures
as specified in «2.0 Technical data» in the insert manual.
• The cross-section of the chimney must be at least that of the
flue pipe. To calculate the correct chimney cross section, see
«2.0 Technical data» in the insert manual.
• Several solid fuel products can be connected to the same
chimney system if the chimney cross-section is adequate.
Contact your local building authorities regarding restrictions
and installation requirements.
• Connection to the chimney must be performed in accordance
with the installation instructions of the chimney supplier.
• Make sure that the flue pipe rises all the way up to the chimney.
• Please note that it is extremely important for connections to
have a degree of flexibility.
For recommended chimney draught, see «2.0 Technical data» in
the insert manual.
3.9 Preparation
NB: Check that there is no visible damage to the product when
you unpack it, and make sure that the control handles move
freely.
The burn chamber is heavy, – make sure it does not topple over
while you are installing it!
Ensure you have help when positioning and installing it.
The product is supplied together with 3 manuals:
1. General user and maintenance manual
2. Jøtul Cube 200 / 400 / 500 / 530 (surround).
3. Jøtul I 400 FL, Jøtul I 500 FL or Jøtul I 530 FL (burn chamber).
Prior to installation, decide on the following:
1. Where the smoke outlet should be.
2. Position of external air connection if being used.
3. Ash collection system if being used.
Refer to manuals for parts installation instructions.
Reducing the weight of burn chamber and protecting parts
during installation:
Fig. 3
E
1. Unpack the insert. Take out the box with contents and,
if necessary, burn plates to make the product lighter.
Remove the heat shield (Fig. 3 E).
2.
Remove the side burn plates (Fig. 3 A) by lifting them
3.
slightly and pulling out. If they are difficult to remove, use
a screwdriver to draw them up.
Then lift the back burn plate out (Fig. 3 B).
4.
Special instructions for the Jøtul I 500 FL:
Pull the air chamber (Fig. 3 C) forward while lifting it at the
5.
front edge. Ease it down and take it out through the door
opening. Be careful – it is heavy!
Lift the exhaust deflector (Fig. 3 D) up at the back edge, push
6.
it slightly backwards. Then lift it down at the front edge, out
through the door opening.
ENGLISH
B
A
D
C
7