Advertisement
Quick Links
Outdoor Stovetop
8 5 - 1 6 0 3 - 8
Read and save this manual for future reference.
If pre-assembled, leave this manual
with unit for consumer's future reference.
For product inquires, parts, and warranty and
troubleshooting support, please call 1-877-707-5463.
S A F E U S E , C A R E A N D A S S E M B L Y M A N U A L
G 1 0 6 0 1
D A N G E R
If you smell Gas
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your
gas supplier or your fire department.
W A R N I N G
1. Do not store or use gasoline or other
flammable vapours and liquids in the
vicinity of this or any other appliance.
2. An LP cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance.
W A R N I N G
Failure to follow all of the Manufacturer's
instructions could result in hazardous
fires, explosions, property damage, or
serious personal injury or even death.
W A R N I N G
Follow all leak check procedures carefully
prior to operation of barbecue, even if
grill was dealer assembled. Do not try to
light this barbecue without reading the
Lighting Instructions section of this manual.
T H I S B A R B E C U E I S F O R
O U T D O O R U S E O N L Y
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for MasterChef Outdoor Stovetop
Summary of Contents for MasterChef Outdoor Stovetop
- Page 1 Outdoor Stovetop S A F E U S E , C A R E A N D A S S E M B L Y M A N U A L D A N G E R If you smell Gas 1.
- Page 2 W A R R A N T Y 1 Year Limited Warranty This Masterchef Outdoor Stovetop carries a 1 year limited warranty against defects in manufacturing workmanship. This Limited Warranty is nontransferable and becomes void if used for commercial or rental purposes. This warranty applies only when unit is used in Canada.
- Page 3 I N F O R M A T I O N The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: I N S T A L L A T I O N Canadian installation must conform to the current national standards, which at •...
- Page 4 The Cylinder must also be equipped with: A shut-off valve with a correct cylinder valve outlet as specified in current standards. • Canada: CAN/ CGA 1.6g-M97 Outdoor Gas Grills. • U.S.A: ANSI Z21.58a-2006/CSA 1.6a-2006 Outdoor Cooking Appliances. • a) Constructed and marked in accordance with the Specifications for LP-Gas Cylinders of the U.S.
- Page 5 F I L L I N G T H E For safety reasons the LP gas cylinder, if supplied with your barbecue, has been shipped empty. The cylinder must be filled prior to use and must have the air L . P . C Y L I N D E R purged.
- Page 6 Attention: Improperly lighting the barbecue can activate the flow control feature, resulting in lower heat output. If this occurs, the re-flow feature must be reset by turning off all the burner controls and the cylinder valve. Wait at least 30 seconds before slowly turning on the cylinder valve, and then after another 5 seconds turn the burner valve on and light the barbecue.
- Page 7 P R I O R T O U S I N G Do not use your barbecue until you have carefully read and fully understand all the information in this manual. Please ensure the following: Your barbecue is properly assembled. •...
- Page 8 L I G H T I N G Prior to lighting your Outdoor Stovetop, visually check all hoses before each use, for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any T H E B A R B E C U E way, do not use your barbeque.
- Page 9 Match-Lighting Do not lean over burner while lighting. 1. Remove lid. Turn on gas at LP cylinder. 2. Place lit match into match holder. Place match near burner. 3. Push in and turn burner knob to HI. Be sure burner lights and stays lit. W A R N I N G Use this slot for manual match lighting If the heat output is too low, the flow control feature may have...
- Page 10 S A F E T Y C H E C K Burner Check Light burner, rotate knob from HI to LOW. You should see a smaller flame in the LOW position than the HI position. Always check flame prior to each use. Burner Flame Check Inspect burner prior to each use.
-
Page 11: Troubleshooting Guide
T R O U B L E S H O O T I N G G U I D E Problem Possible Causes Corrective Action Burner will not light Blocked venturi tubes Clean out blockage • • (match or igniter) Cylinder or gas supply valve turned off Open cylinder or gas supply valve •... - Page 12 P A R T S L I S T Item No. Quantity Description Part No. Top Lid G106-0008-01 8 5 - 1 6 0 3 - 8 ( G 1 0 6 0 1 ) Handle, Top Lid G402-0001-02 Top Support Frame G106-0200-01 Cooking grate G106-0007-01...
- Page 13 Manual Hardware Pack...
- Page 14 A S S E M B L Y I N S T R U C T I O N S Hardware Pack List Key No. Description Part Number Quantity Tools needed for assembly are shown below. No.10-24 UNC x 25 Screw 20124-10025-03A ø5 Washer 40300-05000-250...
- Page 15 Insert 3 vertical supporting bars (CH) into tank support (DA). Secure the supporting bars to the tank support using hardware #1 (x6) and #2 (x6). Assemble the side panel (CF), front panel (CE) and support- ing bars (CH) together as shown using hardware #3 (x16). Assemble the igniter (CB) to the control panel (CA) as shown.
- Page 16 Position the control panel (CA) into the hole located on the front panel (CE) using hardware #3 (x4). Place the control knob (CC) on as shown. Assemble the cart handle (CJ) to the side panel (CF) using hardware #6 (x2) as shown. Assemble the Bracket Holder (CK) to the bottom of Heat Shield (BE) using hardware #11 (x2) as shown.
-
Page 17: Very Important
7.1 Assemble the burner assembly (BC) to the heat shield by positioning the burner Venturi tube through the hole located in the heat shield, using hardware #7 (x3). 7.2 Assemble the heat shield and burner to the top of the cart body using hardware #3 (x4). - Page 18 Assemble the back panel (CG) by attaching to the heat shield as shown. Then place lid to cover the top of this unit. C A U T I O N Lid should only be used for storing after Side burner unit has cooled down. Never place cover over burner when unit is in operation.
- Page 19 Remove one of the hardware #3 (self tapping screw) from the Front Panel (CE), then connect the Retention Hook to the Front panel (CE) as shown using the same hardware which was just removed (hardware #3) and a 5mm washer (hardware #2). Important! Clip the regular PVC hose to the hook as shown before connecting the QCC1 regulator to the gas tank.
- Page 20 D I S T R I B U T O R Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8...
Need help?
Do you have a question about the Outdoor Stovetop and is the answer not in the manual?
Questions and answers