Appendix
Programming Codes of PT850
Load all parameters factory defaults
Enable/Disable Programming Codes
Disable
Enable
Laser's Duration of Time
If need to set the laser's duration of time as 3 seconds, follow the steps below:
1. Read the programming code below.
2. Read digit "3"and "0"
Set Prefix and Suffix
1. Read the barcode you want to program.
2. Refer to the "Table 1"to get the ASCII value.( A: 1065)
3. Read the 4 digits you get.
Prefix
Suffix1
Data Format Cancel
Suffix2
Set Data Format
<Data> <Suffix1>
Data as is
<Data> <Suffix2>
nlscan.com
Page 34