Advertisement
OPERATION INSTRUCTIONS
Before the first use
•
Clean the cooking pot with hot water, mild detergent and a
non- abrasive sponge. These parts are safe to be cleaned
in a dishwasher.
•
Wipe the interior and exterior of the appliance with a cloth.
•
There is no need to fill the pot with oil and frying fat.
Hot Air Frying
1. Connect the mains plug into an earthed wall socket.
2. Put in place the cooking pot and the suitable accessory
(e.g. low/high rack) and the ingredients to be cooked.
Note: Do not stack the food close to the heating element or the
food may get charred.
Note: If the low/high rack and steamer is used, please add
suitable amount of water into the cooking pot.
Optional: The included filter accessory can be used as added
protection for the fan and heating component. Attach to the
black grill under the lid according to the direction of the arrow
on the filter.
3. Switch the lid release to unlock position and
pull down the lid to close.
6 INSTALLATION AND OPERATING INSTRUCTIONS
4. Press the start key once and the product enters stand- by mode.
5. Press the Start key to select appropriate Mode (see 'Mode'
section page 9-10 for default time and temperature). The
corresponding default time and temperature will be shown on
the LED display screen.
6. Press the + and - Temperature buttons to decrease or increase
the temperature to the desired target temperature.
See section 'Settings' page 7-8 to determine the right
temperature and settings
7. Determine the required cooking time for the ingredient
(see 'Settings' section page 7-8.) Press the + and - Time
adjustment buttons to decrease or increase to the required
cooking time.
Note: Time and temperature may be set to the individual need (If
no mode setting is assigned, the product can still operate if time
and temperature is set).
8. Press the Start key to begin the cooking process.
Note: During the hot air frying process, the inside light comes on
and goes out from time to time. This indicates that the heating
element is switched on and off to maintain the set temperature.
The process repeats until the set time is reached.
Advertisement
