Pride QUANTUM JAZZY SERIES Owner's Manual page 28

V . C O M F O R T A D J U S T M E N T S
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip
wheels are preset at the factory for smooth surfaces or indoor use only. If you plan on using your power chair on
rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may
need adjustment if either of the following occur:
When coming to a stop, your power chair tips forward excessively.
The anti-tip wheels constantly rub the ground.
To adjust the anti-tip wheels:
1. Place a wrench on the inner locknut of the anti-tip bracket located right after the shock strut. See figure 19.
2. Turn the locknut counterclockwise to loosen the cam.
3. Place your wrench on the adjustable cam located on the other side of the locknut.
4. To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the cam
clockwise. See figure 20.
5. Tighten the locknut.
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair's
tendency to tilt forward when coming to a stop. You can compensate for this by having your
authorized Quantum Rehab Provider make a small adjustment to the pre-programmed
deceleration setting in the controller or by moving the seat assembly farther to the rear of your
power chair.
WARNING! Consult your authorized Quantum Rehab Provider before attempting to change the
anti-tip wheel height! Changing the anti-tip wheel height affects handling under deceleration!
PROHIBITED! Do not remove the anti-tip wheels.
Figure 19. Anti-Tip Adjustment (Inner Locknut)
28
Figure 20. Anti-Tip Adjustment (Cam)
www.pridemobility.com Quantum Jazzy 1420 Series