Sharp LC-26D4U Service Manual page 27

C
Start measurement
Adjust RB to the target xy values.
MG5RXXXX
MG5BXXXX
* XXXX indicates the adjusted values between 0000 and 1023
(4 digit decimal number with zero fill).
* G is fixed.
* The default adjustment value of RGB is the parameter value
Repeat until RGB
of the LEV5 command multiplied by 2.
become the target
values.
Adjustment gradation setting (point 4 = 170 gradation adjustment*)
LEV40170
Correction of G value
MG4GXXXX
When G is changed at gradation 6, calculate the ratio of the
change and set the following value to XXXX: (the value set with
LEV4) x 2 x (the ratio).
Start measurement
Adjust RB to the target xy values.
MG4RXXXX
MG4BXXXX
* XXXX indicates the adjusted values between 0000 and 1023
(4 digit decimal number with zero fill).
* G is fixed.
* The default adjustment value of RGB is the parameter value of
Repeat until RGB
the LEV4 command multiplied by 2.
become the target
values.
Adjustment gradation setting (point 3 = 120 gradation adjustment*)
LEV30120
Correction of G value
MG3GXXXX
When G is changed at gradation 6, calculate the ratio of the
change and set the following value to XXXX: (the value set with
LEV3) x 2 x (the ratio).
Set
The adjustment value is
reflected in the image.
Adjustment values are set.
OK
attern display
Adjustment values are set.
OK
Adjustment values are set.
OK
The adjustment value is
reflected in the image.
Adjustment values are set.
OK
attern display
Adjustment values are set.
OK
Adjustment values are set.
OK
27
LC-26D4U
LC-32D4U
LC-37D4U