Cleaning The Printhead Resistor Line - AGFA Drystar 5500 User Manual

Cleaning the printhead resistor line

Printhead cleaning must be done when image quality problems occur.
For more information on maintaining image quality: refer to
ning
image quality and resolving Image quality problems'
Drystar 5500 Reference manual.
To clean the printhead:
1
Press the Key-operator key to enter the key-operator mode.
2
On the Key-operator Main menu, press the Down key six times, followed by
the Confirm key to select 'Calibration'.
1 Stop printing
2 Show settings
3 Change settings
4 Print image
5 Save configuration
6 Restore configuration
7 Calibration
8 Installation
The 'Select Calibration' screen appears:
SELECT CALIBRATION
1 Film
2 Printhead profile
3 Printhead cleaning
3
Press the Down key two times to select 'Printhead cleaning' and press the
Confirm key. The printer will automatically shut down.
2901B EN 20040413
Key-operator
Main menu
quit
ok
select
Key-operator
Calibration
quit
ok
select
'Maintaining
on page 188
Advanced operation (key-operator mode)
of the
51