Acer S1383WHne User Manual page 35

About Acer SmartPen Setting
Note 1: Preparations
1. Turn off the projector by pressing the Power button.
2. Use a screwdriver to remove the screw from the cover. (Illustration #1)
Push up and remove the cover. (Illustration #2)
Plug the PB dongle into the PB dongle slot on the projector. (Illustration #3)
Reverse the above steps. (Illustration #2#1)
1 1
3. Connect the projector to your computer with a USB cable and VGA cable.
4. Turn on the projector and make sure it is projecting the computer's display.
5. Enable the pen by selecting "On" in the Settings > SmartPen > Pen Function
menu. The pen's link light will start to blink.
6. When the green light stays on, the connection is successful.
7. Point the pen at the screen to point, click or drag.
Note 2: Overview of the Acer SmartPen
1
6
Rear side
Note 3: Charging the battery
1. To charge the battery, open the flap on the back of the pen to expose the
USB port.
2. Take the USB cable, and plug the smaller connector into the pen and the
larger one into a computer. Make sure the computer is turned on.
3. The battery light stays on while the battery is charging. When charging is
complete, the battery light turns off. You can then disconnect the USB
cable, or leave it connected.
Note 4: Other notes about using the pen
1. Avoid standing too far from the screen. The closer you are to the screen, the
better performance the pen has.
2. Hold the pen the way you hold a remote control or a pen.
3. A full battery charge takes 3-4 hours and will allow 30 hours non-stop use.
The battery is only rechargeable, and is not user serviceable or user
replaceable.
4. Avoid shadows! The pen cannot work if its tip is in a shadow or it is pointing
at a shadow.
2
Upper side
2
3
4
5
7
3
# Description
1 Nib
2 Left mouse button
3 Right mouse button
4 Information key
5 Link light
6 Power switch
7 USB connector
25