Setting - Acer S1383WHne User Manual

22

Setting

SmartPen The Acer SmartPen can work in place of your regular computer
mouse. Just hold the pen in your hand, and point it at the
projected image to point, click, and drag. It gives you more
flexibility to operate your computer without standing next to it.
Pen Function
To use the Acer SmartPen, select "On" to activate this function.
Link Channel
Set a channel to differentiate between projectors and
communicate with the Acer SmartPen.
Dual Pen
Choose "Enable" to stay on Dual Pen mode; choose "Disable" to
return Single Pen mode.
Double Click Speed
Adjust the double click speed of your pen to make it response
faster or slower to meet your needs.
Pen Pairing
To pair a pen, select "Pairing" and follow the on-screen
instructions. To release a pen, select "Release" and follow the on-
screen instructions.
Information
Displays more information about smart pen such as battery
capability and RF strength.
For more details, see the notes following this table.
Mac OS Optimization
If the screen shows the offset phenomenon when using SmartPen
function under Mac OS, it's required to select "On" to optimize and
correct it.
Note: Mac OS Optimization is for Mac OS only.
Startup Screen Use this function to select your desired startup screen. If you
change the setting, the changes will take effect when you exit the
OSD menu.
•
•
Screen Capture Use this function to customize the startup screen. To capture the
image that you want to use as the startup screen, follow the
instructions below.
Notice:
Before proceeding with the following steps, make sure that the
"Keystone" is set to the default value 0 and the aspect ratio is set
to 4:3. For details, refer to the "Image" section.
•
•
•
•
•
•
Acer: The default startup screen of your Acer projector.
User: Use memorize picture from "Screen Capture" function.
Change the "Startup Screen" from the default setting "Acer"
to "User".
Press "Screen Capture" to customize the startup screen.
A dialog box appears to confirm the action. Choose "Yes" to
use the current image as your customized startup screen. The
capture range is the red rectangular area. Choose "No" to
cancel the screen capture and exit the onscreen display (OSD).
A message appears, stating that the screen capture is in
progress.
When the screen capture is finished, the message disappears
and the original display is shown.
The customized startup screen, as shown below, takes effect
when there is a new input signal or when you restart the
projector.