NA-F60A6, F70A6, F756A, F70G6, F70G6P, F70X6, F806X
4.2 Connect the water supply hose
Screw (4)
Water tap
adaptor
Lever
4.3 Install washing machine to steady
Adjust height of leg
1. Turn the adjustable leg knob towards (Loosen)
direction to loose it.
2. Turn the adjustable leg to adjust the levelness.
2.1 When increasing height, turn adjustable leg
towards (Loosen) direction.
2.2 When decreasing height, turn adjustable leg
towards (Tighten) direction.
3. Turn the adjustable leg knob towards (Tighten)
direction to tighten it.
Adjustable leg knob
4.4 Child Lock program
Less than
10 sec.
More than
10 sec.
Water faucet
A
B
Water supply
hose cover
Loosen
Adjustable leg
To raise
Press the [ POWER OFF/ON ] button for at least
5 seconds. The buzzer sounds (2 times for setting)
and the [ CHILD LOCK ] indication turns on.
Buzzer on
Water drain
[ Note ]
- Firmly tighten part B of the water tap adaptor,
otherwise, water leakage will result.
- When the hose must be reinstalled (after you remove).
For example, turn B to the left until about 4 min., of the
thread becomes visible, then carry out the procedure
described above.
- If a water tap adaptor is already connected, replace
with the attached new one.
If the floor is largely inclined.
Use board or
a like for prop
up under leg
of washing
machine.
Tighten
To lower
Open lid
Close lid
Buzzer on and
abnormal alarm
- 9 -
Approx. 4 mm
B
Buzzer off
Unplug the power
cord from the
outlet and re-plug
it again after
5 seconds