Stack Configuration (Optional) - Dell Networking N2000 Series Manual

Switch dell networking n2000 series

Hide thumbs Also See for Networking N2000 Series:

Table of Contents

Stack configuration (optional)

Note: If you already completed Section 2 you are finished. If you wish to use a stack configuration

instead of LAG, follow the instructions below instead of Section 2.

Note: One advantage of stacked switches is that they can be managed as a single switch; however

firmware updates will update and reboot all members of the stack simultaneously and therefore should

only be done during planned downtime.

Connect the cables between the stacked switches. (Stacking ports are on the rear side of the

switch).

2. On both switches, type the following commands to clear the current configuration:

console>enable

console#reload

Are you sure you want to reload the stack? (y/n) y

Note: The switch will reboot.

Follow the prompts shown below when the Main Menu is displayed during the bootup process.

Dell Networking Boot Options

============================

Select a menu option within 3 seconds or the Operational Code will start

automatically...

1 - Start Operational Code

2 - Display Boot Menu

Select (1, 2)# 2

Boot Main Menu

==============

- Start Operational Code

- Select Baud Rate

- Retrieve Logs

- Load New Operational Code

SCG1015

Dell Networking N2000 Series Configuration Guide

Table of Contents