Tools Needed - GE DDE7200S Use And Care Manual

Tools Needed

A phil lips screwdriver is needed to reverse the dryer door.
Dryer Door
1. Open the door and remove the filler plugs
from the side of the opening without hinges.
2. With the door
completely open,
remove the bottom
screw from each hinge
on the dryer face.
3. Insert these screws
about half way into
the top holes, for
each hinge, on the
4. Loosen the top screw from
each hinge on the dryer face
5. With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it up and out.
(on models so equipped)
I
6. Rotate the door 180°. Insert it
on the opposite side of the
opening by moving the door
in and down until the top
hinge and the bottom hinge
are resting on the top screws
inserted in step 3.
7. Remove the remaining
screws from the side of
the opening from which
the door was removed. '
With these screws,
secure each hinge at
the bottom.
8. Tighten the two top
screws of each hinge.
9. Reinsert the plastic plugs on
the side from which the door was removed.
l\\
, @ Q- .